Interior & Trim: Door trim, pillars, headliner, console, glovebox, panel bending

Impact-centered Ducts & Covers: HVAC ducts, wire trays, lightweighting of electrical covers → improved thermal efficiency

Seats & Internal Structures: For impact absorption / sound damping (NVH improvement)

Battery Housing Components: Cell module separators, covers (non-structural parts)

Drone Frames & Arms: Weight reduction, longer flight time, improved battery endurance

Covers & Fairings: Lightweight + impact resistance

Military lightweight cases: Weight reduction for transport equipment, low ballistic requirement parts

TV & Monitor Back Covers: Large flat structures, lightweight & paint-free advantage

Appliance Housings: Vacuum cleaners, air purifiers, refrigerator panels → impact & appearance quality critical

Small Device Covers: Coffee machines, charger housings, etc.

Cable Ducts & Covers: Lightweight critical during installation

Lightweight Pallets & Packaging: Can replace EPS/EPP (reinforced impact-resistant foam)

Interior Panels & Sound-absorbing Materials: NVH improvement + ESG benefits

Medical Device Housings: Chemical resistance + lightweight

Rehabilitation & Healthcare Equipment Covers: Wheelchairs, assistive devices → improved mobility

Suitable: Bending & impact-dominant / low compression & fastening load parts
Interior panels / trims, duct/infrastructure parts, electrical covers, housings/cases

Etat Solide foam technology is optimized for bending & impact-centered lightweight parts, while compression or fastening load parts can be combined with reinforcements/composites to expand versatility.